Adjust of brightness of power on/off LED.

[eudziew]

Hi all !

I'm using the Zero from a wile and works without any problem also the performance are fine for me but there is one small detail which is quite annoying power LED !. The LED in my opinion dim not enough when zero goes to sleep-mode and I will like to change it Dear colleague's do any one can help me or just guide me to related setting or subject about it ? Thx in advance for your help !


Wysłane z iPhone za pomocą Tapatalk

 

[markfarner]

Menu > Setup > System > Display Setup > in Standby push remote control left arrow to dim or put off. (In BH 2.1.5.)

 

[eudziew]

Menu > Setup > System > Display Setup > in Standby push remote control left arrow to dim or put off. (In BH 2.1.5.)

Ok thank you I will try later at home thx !


Wysłane z iPhone za pomocą Tapatalk

 

[eudziew]

Menu > Setup > System > Display Setup > in Standby push remote control left arrow to dim or put off. (In BH 2.1.5.)

Again thank you ! The dim level do not full fill my need so the LED is turned off wile sleep mode and now makes clear information


Wysłane z iPhone za pomocą Tapatalk

 

[djwatt3]

Hello, I didn't find it in BH 3.0.9C, someone can help me?

 

[nunigaia]

Hello, I didn't find it in BH 3.0.9C, someone can help me?

The answer was given for BlackHole 2.1.5 post #2. The same answer for BH 3.0.9.

Menu > Setup > System > Display Setup > in Standby push remote control left arrow to dim or put off

best regards
nunigaia

Note: Make an "ONLINE UPATE" of your image.

 

[djwatt3]

The answer was given for BlackHole 2.1.5 post #2. The same answer for BH 3.0.9.

Menu > Setup > System > Display Setup > in Standby push remote control left arrow to dim or put off

best regards
nunigaia

Note: Make an "ONLINE UPATE" of your image.

Thanks,
The dim didn't work, only on/off.