This board is now closed. The Blackhole image ended in 2020. The board will remain available in Read Only Mode, so all the posts from the last 15+ years are not lost. We thank you for being part of the community for the last 15+ years. You can join the OpenBh board if you have not already done so at www.openbh.net.

BH thinks i have a motor/rotor instead of wf t90

V

vinduo

Vu+ Newbie
I have set up my wavefrontier t90 with 10 lnb'sadvanced setup same as did on vti and pli
diseqc 1.2
lnb 1 input one aa
lnb 2 input one ab
up to
lnb 10 input tree ab
uncom/com/tone
etc
But now when i switch channels to another sat it shows the turning sattelite picture O.0 and switching channels takes very long that way .
What am i forgetting or doing wrong ?
 
You must log in or register to reply here.
Back
Top