This board is now closed. The Blackhole image ended in 2020.
The board will remain available in Read Only Mode, so all the posts from the last 15+ years are not lost.
We thank you for being part of the community for the last 15+ years.
You can join the OpenBh board if you have not already done so at www.openbh.net.
Blackhole 3.0.5L Rebooting problem
- Thread starter any-mgzt
- Start date
angelofsky1980
BlackHole Driver Specialist
More details are needed.
I've flashed recently my Solo2 and all works regularly without unwanted reboots or errors....
Re-booting either indicates a problem that occurred during flashing, a corrupted file, that didn't download correctly, or corrupted USB stick, or a hardware fault.
The first thing I would try is unplugging the receiver, then remove everything that isn't needed, anything connected to the USB ports and especially the LNB cables.
Just have the HDMI lead connected, then start up your receiver and see if it boots up normally.
The first thing I would try is unplugging the receiver, then remove everything that isn't needed, anything connected to the USB ports and especially the LNB cables.
Just have the HDMI lead connected, then start up your receiver and see if it boots up normally.
AlexWilMac
Moderator
Hss this started IMMEDIATELY after the installing? Or maybe you installed also some plugins or any precompiled settings?
Yes as soon as I reflashed the image.
It seems to have settled down after leaving the box off for a couple of minutes and restarting.
Just an issue with Crossepg and cable channels and the time it takes to download the EPG data.
Kenneth MacLean
Vu+ Newbie
Same here. Box reboots, but no HDMI connection? I suppose I'll be reinstalling BH.