This board is now closed. The Blackhole image ended in 2020. The board will remain available in Read Only Mode, so all the posts from the last 15+ years are not lost. We thank you for being part of the community for the last 15+ years. You can join the OpenBh board if you have not already done so at www.openbh.net.

Date and Time eroor

J

Jan-Egil Jakobsen

Vu+ Newbie
I have a problem with my VU + Duo with Black Hole 2.0.1 OE2 image. every time I start up either from off position or take a reboot then the clock reset to 01.01.1970 and it will not be automatic corrected afterwards, I have to set it manually afterwards every time. but if I then take to restart enigma2 ore start from StandBy Toggle so does it not happen that clock is reset
 
Jan-Egil Jakobsen said:
I have a problem with my VU + Duo with Black Hole 2.0.1 OE2 image. every time I start up either from off position or take a reboot then the clock reset to 01.01.1970 and it will not be automatic corrected afterwards, I have to set it manually afterwards every time. but if I then take to restart enigma2 ore start from StandBy Toggle so does it not happen that clock is reset
Click to expand...

The clock (date & time) are read from satellite (or terrestrial) TPs ..... tune a channel and (usually) the clock go to correct and current date immediately.
 
angelofsky1980 said:
The clock (date & time) are read from satellite (or terrestrial) TPs ..... tune a channel and (usually) the clock go to correct and current date immediately.
Click to expand...
It only happen if i use my backup when i install BH this happend, but not in OpenPLI
but if i rescan all scannel it ok after
ps i upload my backup
 

Attachments

You must log in or register to reply here.
Back
Top