This board is now closed. The Blackhole image ended in 2020. The board will remain available in Read Only Mode, so all the posts from the last 15+ years are not lost. We thank you for being part of the community for the last 15+ years. You can join the OpenBh board if you have not already done so at www.openbh.net.

Diseqc motor positioner problem (uno4kse, BH3.0.8)

kodosh23

kodosh23

Vu+ Newbie
Hey, I recently purchased a diseqc motor, to make things easy, yet I am unable to set it right. I have set up Tuner A as Simple/Positioner with longitudes and latitudes where I live in Bavaria. I think I have applied (perhaps wrongly) 19,2 E coordinates for the "go to 0" position... so i have ok SNR for the "0" position but when I go to various sats to search for channels, the motor rotates to strange sat numbers. Any tips on how to proceed are much appreciated. cheers. ([pic attached)
 

Attachments

  • IMG_1343.jpg
    IMG_1343.jpg
    244.4 KB · Views: 26
You must log in or register to reply here.
Back
Top