Request DVB-T manual scan: show UHF frequency

SatDreamer

SatDreamer

Vu+ User
Could you please add a way to enter the regular, 2-digit UHF frequencies (the range is between 21-69 over here) for a manual DVB-T scan, instead of the complicated and impossible to remember MHz numbers? Thanks.
 
SatDreamer said:
Could you please add a way to enter the regular, 2-digit UHF frequencies (the range is between 21-69 over here) for a manual DVB-T scan, instead of the complicated and impossible to remember MHz numbers? Thanks.
Click to expand...

Enigma2 boxes uses full frequency instread the human channel. It's not possible to convert the frequency into channel.
 
Thanks. Aren't these numbers fixed? I mean yes, they are different for each country/region but still, doesn't a full frequency number always correspond to a specific UHF frequency? I am not talking of course about the "preset" number we use in our TV's or 'favourites' bouquet.

Here are all the numbers. It should be just a matter of selecting the correct region and showing the extra, 2-digit corresponding number, there is nothing to convert/calculate.
 
Last edited:
SatDreamer said:
Thanks. Aren't these numbers fixed? I mean yes, they are different for each country/region but still, doesn't a full frequency number always correspond to a specific UHF frequency? I am not talking of course about the "preset" number we use in our TV's or 'favourites' bouquet.

Here are all the numbers. It should be just a matter of selecting the correct region and showing the extra, 2-digit corresponding number, there is nothing to convert/calculate.
Click to expand...


The problem is even more complex for DVB-T
because the center frequency is not the same in all countries
and depends on the bandwidth.

bandwidth - the space in the spectrum that each channel use.
 
You must log in or register to reply here.
Back
Top