This board is now closed. The Blackhole image ended in 2020. The board will remain available in Read Only Mode, so all the posts from the last 15+ years are not lost. We thank you for being part of the community for the last 15+ years. You can join the OpenBh board if you have not already done so at www.openbh.net.

Frusrated 43yr old requires.........

T

tomainzy

Vu+ Newbie
Help with his Vu+Uno.For some reason it won't boot!It just shows the spinning VIX emblem.Not sure what it could be.It's happened 3-4 time's now.I wonder if it is connected to it happening when the power is off and not just in standby.It happened again today when after freezing,I rebooted it.Normally it's just left on standby.
Any help appreciated as i'm thinking of getting rid and just using my old but reliable Dreambox 500s.
 
It won't boot at all or it boots eventually after turning it off and on several times? If the latter, then make sure your USB flash disk is NOT ext2 or ext4 formatted. If yes format it to FAT32.

PS: This is Black Hole image dedicated forum :-)
 
No need Vu+ STB...and the Uno is one of the best!
Now lets solve your problem!

Lets put aside the Vix image and go for BH image 2.02!
Remember to save your settings (use software manager only)
After You flash the new image we can go further!
 
Katikakus said:
It won't boot at all or it boots eventually after turning it off and on several times? If the latter, then make sure your USB flash disk is NOT ext2 or ext4 formatted. If yes format it to FAT32.
Click to expand...


Yes its good idea , always Erase Format (FAT32) the USB,,,before extracting any image to it!
 
I wanted to use a BH image originally but a friend recommended Vix which,to be fair,has been ok until this begun happening.I will however try to install the BH image instead.
 
Hi a911
I have installed 2.0.2 , fpga upgrade & available online updates but,cannot seem to configure the Tuner!
Stressed!
 
Not sure if i'm doing anything wrong but,from my experience with PLi & Vix,the reciever normally recognises and clears 28.2º without issue.
 
tomainzy said:
Hi a911
I have installed 2.0.2 , fpga upgrade & available online updates but,cannot seem to configure the Tuner!
Stressed!
Click to expand...

Menu>Setup>Service Searching>Tuner Configuration
I do not have UNO,,,but here my Due config,,,as a guide line:-

screenshot.jpg

Its realy easy,,,just go slowly,,Black Hole is user friendly image,,,and in no Time U'll be a BH Lover...:D!
 
Thanks very much folks.I just need to sort my 'Extras' now.
Are there any 'must haves' that should be installed too?(i've done the fpga upgrade and BH update aswell as 1 Channel.
 
tomainzy said:
Thanks very much folks.I just need to sort my 'Extras' now.
Are there any 'must haves' that should be installed too?(i've done the fpga upgrade and BH update aswell as 1 Channel.
Click to expand...

No not really!
Its the users choice!
Just use the plugins that is available @BH addon server!
 
You must log in or register to reply here.
Back
Top