This board is now closed. The Blackhole image ended in 2020. The board will remain available in Read Only Mode, so all the posts from the last 15+ years are not lost. We thank you for being part of the community for the last 15+ years. You can join the OpenBh board if you have not already done so at www.openbh.net.

Help with settings

M

Mickeith

Vu+ Newbie
Hi, I have a Vu+solo and I think I messed up some settings because everything was working fine but now every time I change satellite I need to reposition, ex I'm on 13e and to go to 19e satellite I will not be available until I do the process of positioner setup. I'm not on usals and my dish it's with a rotator motor. The thing is that I need to press limit east, west & limits on so it can be saved. Your help would be much appreciated guys & gals
 
Are you saving the diseqc 1.2 position when you do the process of positioner setup? In the Positioner Setup Menu, Reposition your motor, then highlight Memory index and press the green remote button to save the position.

Be careful setting the East/ West limits because you can severely limit the motor travel or stop the motor movement if they are not set correctly. You may want to turn limits off until you get the motor tracking correctly.
 
Thanks for your reply, that exactly is my problem that if I not press limits on the motor will not store the position. Further to you the diseqc yes it's saved as 1.2 I think I'll better upload some pictures of my configuration cause something is messed up..!!!
 
You must log in or register to reply here.
Back
Top