This board is now closed. The Blackhole image ended in 2020. The board will remain available in Read Only Mode, so all the posts from the last 15+ years are not lost. We thank you for being part of the community for the last 15+ years. You can join the OpenBh board if you have not already done so at www.openbh.net.

How to change channel name?

N

Nalleman

Vu+ Newbie
Hello!
I'm new to VU+ DUO2 and so far I'm not that thrilled. I think my Vantage 8000 HD is much simpler to handle but maybe I'll get used to my new receiver too.
My problem is when I search for certain channels the real name of the channel does not appear in the channel list. Instead I see the frequency and a lot of numbers. For example when loading the RAI channels located on Hotbird an 10 992V I can't see RAI1, RAI2 and so on in the channel list. I just see "10 99V" and a lot of numbers. When I searched another RAI transponder 11 766V this problem didn´t occur. Can anyone tell a total newbie how to solve this?
Sorry for a simple (but for me diffucult) question.
I should also say - I'm really sorryif posting this in the wrong section.
 
This kind of issue is due to the broadcaster, not to receiver.
Sadly, it happens often to the Rai channels on HB.
 
Mito said:
This kind of issue is due to the broadcaster, not to receiver.
Sadly, it happens often to the Rai channels on HB.
Click to expand...
Oh I really didn't know that. I have never had this problem with RAI before. However my question remains. Is it possible to edit a channel name? On my Vantage this is a really simple task to perform.
 
The DreamEdit is a powerful and easy to use utility which can edit the channel information and parameter.
1. Download the utility software (everywhere in the internet) and install it to your pc.
2. Set the your receiver's IP as required in the configure interface of Dreamedit.
3. download your channel list from your receiver and edit it, upload the edited list back.

just as simple as it. It is very easy to do the edit from you pc's keyboard.
 
I'm sorry Angelo, I had seen that it was the international forum
thanks anyway now try again to use Dreamset since I created a few problems before
 
mysat-bs said:
The DreamEdit is a powerful and easy to use utility which can edit the channel information and parameter.
1. Download the utility software (everywhere in the internet) and install it to your pc.
2. Set the your receiver's IP as required in the configure interface of Dreamedit.
3. download your channel list from your receiver and edit it, upload the edited list back.

just as simple as it. It is very easy to do the edit from you pc's keyboard.
Click to expand...
Thanks!! Great forum this! :)
 
You must log in or register to reply here.
Back
Top