How to control vu+ zero and uno 4k se both in one room.

D

dhnj

Vu+ Newbie
Hi
I have a vu+ zero and uno 4k se both in one room.
When I use the zero or uno remote control the
signal is picked by both units. Can you limit the
zero remote signal is not picked up by the uno
and vice versa.
Best regards
 
dhnj said:
Hi
I have a vu+ zero and uno 4k se both in one room.
When I use the zero or uno remote control the
signal is picked by both units. Can you limit the
zero remote signal is not picked up by the uno
and vice versa.
Best regards
Click to expand...

You must set one of the remote controls to another remote control code.

By default you have both remotes with 0002 code ... you can set the remote control of zero per example as ( 0003 ).

1) Turn off the UNO4k ...

2) Set the remote control of ZERO to 0003, by:

1. Press 2 and 7 for three seconds until LED is on.
2. Press HELP
3. Press <0003>

After 3 blinks the RCU should be setted to code 0003.

Use now the UNO4K remote control and under plugins ... change the "remote control code" ... from 2 to 3...
After set it to 3 ... save this setting by using the "zero remote control to keep this settengs".

Now you should have one command to control UNO4K and other to control ZERO separately.

best regards
nunigaia
 
Primero el receptor, luego el mando a distancia.:D First the receiver, then the remote control.:D
Deja en reposo el que no quieras cambiar/Leave in Standby the one that you do not want to change.

Ejemplo/Example.
Configuracion_mando_img_a10614.jpg.jpg
 
Last edited:
nunigaia said:
You must set one of the remote controls to another remote control code.

By default you have both remotes with 0002 code ... you can set the remote control of zero per example as ( 0003 ).

1) Turn off the UNO4k ...

2) Set the remote control of ZERO to 0003, by:

1. Press 2 and 7 for three seconds until LED is on.
2. Press HELP
3. Press <0003>

After 3 blinks the RCU should be setted to code 0003.

Use now the UNO4K remote control and under plugins ... change the "remote control code" ... from 2 to 3...
After set it to 3 ... save this setting by using the "zero remote control to keep this settengs".

Now you should have one command to control UNO4K and other to control ZERO separately.

best regards
nunigaia
Click to expand...
Many thanks for your quick feedback.
Now each RC controls only one box, but in reverse order.
The zero RC controls uno box & uno RC controls zero box.
Is there a way to assign the right RC to the right box.
Best regards
 
dhnj said:
Many thanks for your quick feedback.
Now each RC controls only one box, but in reverse order.
The zero RC controls uno box & uno RC controls zero box.
Is there a way to assign the right RC to the right box.
Best regards
Click to expand...

It depends how you set your Remote Control and STB ...
You can reverse it ...

Uno4K .... code 3
Zero ....... code 2

or vice-versa

Uno4K .... code 2
Zero ....... code 3

Do it as you want! ;)

best regards
nunigaia
 
You must log in or register to reply here.
Back
Top