This board is now closed. The Blackhole image ended in 2020. The board will remain available in Read Only Mode, so all the posts from the last 15+ years are not lost. We thank you for being part of the community for the last 15+ years. You can join the OpenBh board if you have not already done so at www.openbh.net.

How to upgrade fw VU+ UNO from BH 1.6.6 to BH 1.7.3??

A

ajdelaguila

Vu+ Newbie
Hi!!

I can't upgrade fw versions because of when the deco is booting the 'CH-' message is never shown. I've upgraded succeessfully the FPGA but I don't know how to do it.

Any help will be appreciated :)
Thnx in advanced to everyone!!
 
ajdelaguila said:
Hi!!

I can't upgrade fw versions because of when the deco is booting the 'CH-' message is never shown. I've upgraded succeessfully the FPGA but I don't know how to do it.

Any help will be appreciated :)
Thnx in advanced to everyone!!
Click to expand...
If there is attached an usb stick on a rear port of the Uno, try to remove it before to install the new image.
 
ajdelaguila said:
No, there isn't any usb attached on the rear... only an Avermedia Volar Green HD device.
Click to expand...
The USB tuner should not influence the image upgrade, but you can try to remove it.

However, I think it's only a problem due to the usb stick you are using to upload the image.
Try to use another usb stick.
 
Problem fixed.

Because of your indications, Mito, I have reviewed my USB stick settings and the problem was that the primary partition of the stick wasn't marked as 'Active'.

Thnx very much for your help!!
 
You must log in or register to reply here.
Back
Top