Motor Problem

John Bailey

Vu+ User
Hi all.
Loaded 1.7.3- all fine at first but now the dish motor will not move between Sats'.
The dish and motor are relatively new (installed last june)
I would appreciate any advice or a solution if anyone has experienced the same or similar problem.
I have tried re booting but this did not have any effect.
Tried a previous image but the Vu+ duo would not accept this.

Regards,
John
 
Hi all.
Loaded 1.7.3- all fine at first but now the dish motor will not move between Sats'.
The dish and motor are relatively new (installed last june)
I would appreciate any advice or a solution if anyone has experienced the same or similar problem.
I have tried re booting but this did not have any effect.
Tried a previous image but the Vu+ duo would not accept this.

Regards,
John
Have you setted up correctly the image (Positioner -> your lat/long coordinates) and installed motorized settings?
 
Think I have identified the problem---------------Motor not working.
There is power from the VU+ Duo to the cable and power from the cable to the Dish Motor. Ergo, it must be a Motor fault.

Thanks to those that replied and offerd suggestions.

Best Regards,
John
 
Back
Top