New VU+ Solo2 owner

G

ginjaninja

Vu+ Newbie
hi guys i am a total newbie when it comes to the world of twin tuners, i have had a dreambox dm800 for the past few years so i am pretty up to speed when it comes to enigma 2/ linux systems.

problem i am having so far is

1. box has 2 inputs and no loop thru, which i believe i can get around, problem is i only have one lnb one dish coming from the motor.

2. i had tried to fudge my way through it, so whilst i had something recording earlier i pressed the channel + button to select another channel and all appeared to be available, which was good, however when i tried to select another channel there were limited channels available and the more i done it the less channels are available. what i want to know is, can i exit this so i can get all the channels available, i am currently still recording something so i know one tuner is busy.

3 also another small one i entered in PIP mode and could not find a way out of it without rebooting the box.

any suggestion would be much appreciated.

the ninja
 
ginjaninja said:
hi guys i am a total newbie when it comes to the world of twin tuners, i have had a dreambox dm800 for the past few years so i am pretty up to speed when it comes to enigma 2/ linux systems.

problem i am having so far is

1. box has 2 inputs and no loop thru, which i believe i can get around, problem is i only have one lnb one dish coming from the motor.

2. i had tried to fudge my way through it, so whilst i had something recording earlier i pressed the channel + button to select another channel and all appeared to be available, which was good, however when i tried to select another channel there were limited channels available and the more i done it the less channels are available. what i want to know is, can i exit this so i can get all the channels available, i am currently still recording something so i know one tuner is busy.

3 also another small one i entered in PIP mode and could not find a way out of it without rebooting the box.

any suggestion would be much appreciated.

the ninja
Click to expand...

1. You can use loopthrought function avaiable into GUI to connect Tuner B to tuner A
3. Long press Blue Button and you can disable PIP functions :)
 
It is not your tuner which is busy, but your single LNB....
Do not forget that with a single LNB and a dual tuner, if you record something then you can only see a program from the same sat, same polarity ( H or V) and same band (high or low).
 
You must log in or register to reply here.
Back
Top