Nightmare ! Tuner set up motor dish

[Davon]

Hi

Can anyone please help

I have a solo2 and motor dish with twin LNB ( LNB ports dont say 1 or 2 )
When i run through set up wizard if offers 19.2 and 13 e only I downloaded the channel lists and 13 worked , but when i wanted to see channel on 19.2 dish would not move ! Why does it offer me 13 and 19.2 eI cant seem to set tuner A and B up properly . Also how do i set my home position and save it .
I done a scan yesterday by manually searching found 28,2 e got a lock and saved it . When i went back to green button sat list it was not there

Has anyone got any advice on setting up this config/ tuners for a newbie

Thanks you so much

 

[paolino]

@Davon : Twin LNB is not a good solution for motorised dish. I suggest to you to use a SCR Unicable LNB to discover full power of Solo2.
http://www.vuplus-community.net/board/threads/howto-usals-motorized-dish-and-scr-unicable-lnb.13352/

Your Twin LNB has an internal Diseqc 1.0 switch and is intended for fixed dish use.

 

[Davon]

Hi
Sorry if i explained that wrong
it is 1 LNB with 2 outputs

 

[paolino]

@Davon :
Now it's more clear.
Your case is discussed here : http://www.vuplus-community.net/board/threads/tuner-config-tutorial-for-motor-dish-setup.12884/

 

[Davon]

Thanks
Maybe im being stupid , but i need to know how to set up A and B tuners ( simple /positioner / loop through / advanced / disque A /B ??
And store home co ords

thanks

 

[paolino]

@Davon :
You are not stupid, we just not understand each other .
You should connect motor to Input 1 (A TunerA) and set it as "Advanced", next depends on your motor. USALS or only Diseqc 1.2?
Your geografical position? Use your GPS to have your position (example 45,986 N, 10,345 E)

 

[Davon]

My LNB has 2 out puts ( none are marked as motor / does this matter which out put i connect to Input 1 ?)
My motor is DISEqc H-H motor for 1.2 and 1.3

So do i set A as 1.2 ( what config for Input 2 ( loopthrough , simple / advanced )

Thanks

 

[paolino]

@Davon : Please, post model of your motor and LNB.

 

[Davon]

Motor is technomate TM -2200 super and LNB is just named universal LNB twin from Microelectronic (from e b*y)

 

[Davon]

Looking at motor it originally had a single lnb connected to motor , then a cable from motor to receiver . When i instal TWIN LNB does the other cable run direct from LNB back to receiver ?

Thanks