positioner set up Vu Duo

G

gillian

Vu+ Newbie
When watching BBC I pressed ok on remote twice to see my snr is 53% so I went into set up/service searching/positioner setup and did a fine to east until it went to 96% then saved the setting but when I come out the picture is still showing 53% so it has not saved, any idea what I am doing wrong.

Cheers Chris
Blackhole 1.6.2
 
gillian said:
When watching BBC I pressed ok on remote twice to see my snr is 53% so I went into set up/service searching/positioner setup and did a fine to east until it went to 96% then saved the setting but when I come out the picture is still showing 53% so it has not saved, any idea what I am doing wrong.

Cheers Chris
Blackhole 1.6.2
Click to expand...

I suggest to setup better your dish instead fine tune via STB.
If you use USALS positioner, the fine tuning it's useless because the rotor movements are calculated by the rotor directly and the stored positions are ignored.
 
angelofsky1980 said:
I suggest to setup better your dish instead fine tune via STB.
If you use USALS positioner, the fine tuning it's useless because the rotor movements are calculated by the rotor directly and the stored positions are ignored.
Click to expand...

Hoping to get away from paying a guy to check dish settings.
 
You must log in or register to reply here.
Back
Top