Problems with the tuner

paztero1

paztero1

Vu+ User
Well I put this image (BH 3.6) in my vusolose v2 and in the vu + uno4k and everything is perfect but I see a problem that I did not have before and that I just realized now.
I have both decos with the same antenna and if I use one the other I have it in stamby with which the one that is working I can see the two polarities V and H, but in this last image there is a problem and is that although this in stamby a deco on the other only lets you watch the polarity in which is the stamby deco.
Also it happens to openBH and it is put in its section to see if there is any solution to this subject.
Also tell you that with the latest openspa 7.3.002 this does not happen and works perfectly just as in its previous version.
Is there any solution to this problem?
 
I doubt many people can understand your problem, I've read it a few times and still can't quite work it out, probably due to the online translator.
The only reasons, to experience a problem, similar to what you describe, used to be when you were using the LNB out, to connect to another receiver, so that one receiver only could change the LNB from Horizontal to Vertical, when the other one was in a particular mode.
Please explain this:
"I have both decos with the same antenna and if I use one the other I have it in stamby with which the one that is working I can see the two polarities V and H, but in this last image there is a problem and is that although this in stamby a deco on the other only lets you watch the polarity in which is the stamby deco."

I assume Stanby, is in Standby mode, and Deco means receiver, but what do you mean by using the same antenna? The same dish with a twin output LNB, a monoblock LNB, or other set up?

As I posted, in your other thread, translator programs aren't very good when it comes to technical problems, so it might be better posting in your own language, in the relevant section, of the forum.
 
You must log in or register to reply here.
Back
Top