Dear friends,
is there any possibility to set somewhere a script, that would be run after Solo2 is going from standby to online and vice versa?
Using this script I intend to turn on my audio system (as I don't want to have two remotes on my table).
I have the script ready, but so far didn't find any way of starting it when the box goes onlne/standby.
(currently, the only way to check the state of box is via openwebif using cron, but this causes delay when switching on/off box, as cron runs only once a minute).
Thanks in advance!
is there any possibility to set somewhere a script, that would be run after Solo2 is going from standby to online and vice versa?
Using this script I intend to turn on my audio system (as I don't want to have two remotes on my table).
I have the script ready, but so far didn't find any way of starting it when the box goes onlne/standby.
(currently, the only way to check the state of box is via openwebif using cron, but this causes delay when switching on/off box, as cron runs only once a minute).
Thanks in advance!