This board is now closed. The Blackhole image ended in 2020. The board will remain available in Read Only Mode, so all the posts from the last 15+ years are not lost. We thank you for being part of the community for the last 15+ years. You can join the OpenBh board if you have not already done so at www.openbh.net.

satellites list shows only 13 and 19

C

cuervo

Vu+ Newbie
I have recently installed BH for Solo SE and everything seems to work fine. Thanks very much for the good work !!
I am using a motorized system which can scan any satellite but when I press the green button to see the satellites only 13 and 19 show up. I spend some time reading the forum without being able to find a solution.
I used to work with the Gemini image, which had a tool in the blue panel called "Sat Config" where you could choose the satellites to be configured. Could anybody please tell me what to do to see the other satellites ?

Thanks
 
Can you please check how you have the tuner configured, and are you using Usals, or Diseqc 1.2?
You can add satellites, via the tuner menu options, then configure them using the motor setup menu, which is usueful for fine tuning.
 
cuervo said:
I have recently installed BH for Solo SE and everything seems to work fine. Thanks very much for the good work !!
I am using a motorized system which can scan any satellite but when I press the green button to see the satellites only 13 and 19 show up. I spend some time reading the forum without being able to find a solution.
I used to work with the Gemini image, which had a tool in the blue panel called "Sat Config" where you could choose the satellites to be configured. Could anybody please tell me what to do to see the other satellites ?

Thanks
Click to expand...

You should start with a motorized setting pre-made OR update your satellites.xml file and reboot your box.
 
You must log in or register to reply here.
Back
Top