Setup 8 1 switch EMP-centrauri

[oddy67]

I have bought switch EMP- centauri s871pcp - W2 . it should be connected to the LNB pointed towards o , 8W , 4,8E , 13e , 19E and 28E .
I use DiSEqC 1.1. Comand is uncommitted , committed , ToneBurst all LNB. But I do not get pictures onto Vu + solo.
Can anyone help ? Thanks in advance

 

[nunigaia]

I have bought switch EMP- centauri s871pcp - W2 . it should be connected to the LNB pointed towards o , 8W , 4,8E , 13e , 19E and 28E .
I use DiSEqC 1.1. Comand is uncommitted , committed , ToneBurst all LNB. But I do not get pictures onto Vu + solo.
Can anyone help ? Thanks in advance

Take a look to this:

• 
  

• Individual LNBs are accessible using following DiSEqC 1.1 commands:
  Sat system (LNB)”committed command” ”uncommitted command”
  A (1)A (1,AA)1
  B (2)B (2,AB)1
  C (3)C (3,BA)1
  D (4)D (4,BB)1
  E (5)A (1,AA)2
  F (6)B (2,AB)2
  G (7)C (3,BA)2
  D (8)D (4,BB)2
• If the receiver does not support DiSEqC 1.1, user has to resort to DiSEqC 1.2 motor commands (not USALS)
• With standard DiSEqC 1.0 setting only sat systems A to D are available
• Multiswitches are not compatible with Monoblock LNBs
• Stand-by circuitry monitors usage of any LNB and if not watched by any user, shuts off power to this LNB and relevant inner circuits
• Terrestrial input can provide 12 V or 5 V DC (selectable by DIP-switch), up to 150 mA
• If higher than available number of user outputs is required, simply use two multiswitches instead of one, routing LNB outputs via signal splitters
• Terminate all unused outputs by 75 ohm loads, if terrestrial band is used

If the receiver does not support DiSEqC 1.1, user has to resort to DiSEqC 1.2 motor commands (not USALS)
Best regards
nunigaia