I have a setup with a Clarke-Tech V4000 VBOX diseqc 1.2 positioner. Positioner is connected to tuner A. LNB on dish with actuator is behind a Diseqc 1.0 switch, port A. In port B of Diseqc 1.0 switch there is an EMP Centauri Diseqc 1.1 switch, driving 16 more LNBs.
Switching works ok, but when receiver sends committed + uncommitted command, the V4000 powers off. It supports to power off when LNB power is switched off, which is not the case. When it powers off, I need to power it on again from power button. This only happens with Solo2, it wan't happening with my VU+ Duo and VU+ Ultimo I had in the past.
Maybe when sending committed + uncommitted, Solo2 powers off LNB power for very short time, and V4000 is powering off.
It would be nice if this can be reported to VU+ driver developers.
Switching works ok, but when receiver sends committed + uncommitted command, the V4000 powers off. It supports to power off when LNB power is switched off, which is not the case. When it powers off, I need to power it on again from power button. This only happens with Solo2, it wan't happening with my VU+ Duo and VU+ Ultimo I had in the past.
Maybe when sending committed + uncommitted, Solo2 powers off LNB power for very short time, and V4000 is powering off.
It would be nice if this can be reported to VU+ driver developers.