This board is now closed. The Blackhole image ended in 2020. The board will remain available in Read Only Mode, so all the posts from the last 15+ years are not lost. We thank you for being part of the community for the last 15+ years. You can join the OpenBh board if you have not already done so at www.openbh.net.

Solo SE - Standard RCU

M

mesho

Vu+ Newbie
I have the issue with my Standard Remote for Solo SE. Pressing almost any button for the first time works fine. LED on the remote shines and the box responds. But when I press any button again then LED shines only a little bit and the box does not respond. In a couple of seconds the same situation. First press is ok and following ones do not work. There are buttons like volume which never works. Is there any way do do kind of "reboot" of the remote ?
 
I tested 3 sets of batteries and finally it works fine. Sounds stupid but looks like it was the issue with batteries ;o)
 
You must log in or register to reply here.
Back
Top