teesside71
Vu+ Newbie
hi all, have recently purchased a solo2, and flashed with 2.0.9.1. all has been fine until this morning when i went to boot the box the image hung at the logo screen and hung, remote unresponsive.
only option was to switch off at back of the unit, now image will not load, switch on box lights up when touched however then nothing
tried a usb flash to no avail, is a rs232 option available, if so can i use the same image files, or do i need a restore image?
only option was to switch off at back of the unit, now image will not load, switch on box lights up when touched however then nothing
tried a usb flash to no avail, is a rs232 option available, if so can i use the same image files, or do i need a restore image?