Strange problem with motor settings

A

alanb

Vu+ Newbie
Hi,

I have a very strange problem with my motor settings. The motor moves anywhere but 28,2E.... I mean it goes to 31,5E to 26E but not to 28,2e...

Any clue ?

Regards, Alan
 
Are you using USALS or Diseqc 1.2?

Carefully check your antenna settings. If you are using USALS, the motor should move to any available satellite in the arc if everything is adjusted correctly. Make sure USALS is set in antenna settings and verify that the correct latitude and longitude have been entered.

If you are using Diseqc 1.2, then verify that the correct number has been entered for 28,2E in the antenna settings.
 
I am using USALS and that's why I cannot explain why the motor does not move to 28.2e. I checked satellites.xml and that is fine. Is there any other setting on the box ?

Regards.
 
The same problem here
i am using DiSEqC motor stick HH 120 with usals

i move back to 2.0.5 and is fine
 
alanb said:
I am using USALS and that's why I cannot explain why the motor does not move to 28.2e. I checked satellites.xml and that is fine. Is there any other setting on the box ?

Regards.
Click to expand...

How do you have the tuner setup ?

Is it setup as simple -> positioner, or is setup as advanced, and each individual satellite listed ?
 
I have BH 1.7.9 because I consider the most stable image for what I do. Now that I think about it is since I changed image that 28.2E does not work....

Now the question is where do we have the motor settings in E2 ?

In my configuration it says Simple Configuration -> Motor

Any clue ?

Regards
 
You must log in or register to reply here.
Back
Top