Time is wrong even after reboot

H

hyzteric

Vu+ Newbie
Hi everyone,
I've got a silly problem.
The time of my vu+ uno is wrong. It's around 30minutes ahead of time.
It's annoying for the recordings.
I did google a lot about this problem and tried many solutions but none of them worked.

Does anyone have any clue?

Many thanks in advance.

Michel
 
rytas

rytas

Vu+ User
hyzteric said:
Hi everyone,
I've got a silly problem.
The time of my vu+ uno is wrong. It's around 30minutes ahead of time.
It's annoying for the recordings.
I did google a lot about this problem and tried many solutions but none of them worked.

Does anyone have any clue?

Many thanks in advance.

Michel
Click to expand...
Have you tried to reflash box ?
 
H

hyzteric

Vu+ Newbie
It is still an old firmware, I've never flashed it before.
I'll try to do it.
Do you know a good "how to"?
Thank you
 
N

niglou

BH Lover
First upgrade FPGA -> see there www2.vuplus.com/14-vuplus-articles/91-vu-uno-upgrade
Download BH179, unzip the file.
Then on a FAT32 formatted usb stick put the content of the unzipped file : on your usb you will have \vuplus\uno\the four files of the image
Switch off with rear switch your uno
Insert usb key at front usb slot close to the card readers
Press - key on the vuplus (close to the usb slot), and while still pressing the - key, switch on the rear switch to power the vuplus
Wait 3 seconds and the release the - key
The flash will occur.
When the vuplus will reboot, remove the key.
Done :)
 
H

hyzteric

Vu+ Newbie
Hi again,

The FPGA upgrade is ok, but when I try to flash with the usb key, it just starts the box normally :-/
 
H

hyzteric

Vu+ Newbie
I just tried with another fat32 formatted usb key, still no luck.
The led on the usb key is on, so I can see it is detected. But the box will always boot normally :-(
 
H

hyzteric

Vu+ Newbie
Good news, I had a second usb stick plugged at the back. I unplugged it and it works now. Well it is still "reading usb" but I guess this is good news ;-)
 
You must log in or register to reply here.
Top