ULTIMO 4K Tuner configuration without UNICABLE

[cptnkirk]

Hello - I'm a newbie and just joined this forum - basically because I've searched everywhere to find the correct way of configuring the tuner in my ULTIMO 4K with no 'unicable'.

Hope someone can help or point me where I can find the info.

Here is my setup: I have 4x Quattro LNB's - all goes into the loft onto a "Vantage VT-MS 17/12 TNT" multi-switch - allowing 12 outputs. (See attached picture)
So the 4 quad LNB's are pointing to 28.2 - 23.5 - 19.2 and 13.0
I have 4 cables going direct from the Vantage multi-switch into the ULTIMO 4K receiver - which has 2x DVB-S2 FBC Dual Tuners - so each tuner has 2 cables - one in each LNB-IN

The problem I now have is that I do not know how to configure the tuner correctly and I cannot find anywhere on how to do this without UNICABLE LNB's - at least I have not found it anywhere.
Can I configure Tuner C, D, E, F, G, H and Tuner K, L, M, N, O, P with legacy cable ?????
and if I can - what are the steps to configure each of them?????
Can this only be done with 'unicable lnb's' to configure my setup on the ULTIMO 4K???


**************************************************************
The way it is setup now is as follows:

Setup Tuner A: Vuplus DVB-S NIM(45208 FBC) (DVB-S2)
Configuration mode - simple
Mode - DiSEqC A/B/C/D
Port A - 28.2 Astra 2E/2F/2G
Port B - 23.5 Astra 3B
Port C - 19.2E Ku-band Astra 1KR/1L/1M/1N
Port D - 13.0E Hotbird 13B/13C/13E
Set voltage and 22KHz - no
Send DiSEqC only on satellite change - no


Setup Tuner B: Vuplus DVB-S NIM(45208 FBC) (DVB-S2)
Configuration mode - simple
Mode - DiSEqC A/B/C/D
Port A - 28.2 Astra 2E/2F/2G
Port B - 23.5 Astra 3B
Port C - 19.2E Ku-band Astra 1KR/1L/1M/1N
Port D - 13.0E Hotbird 13B/13C/13E
Set voltage and 22KHz - no
Send DiSEqC only on satellite change - no

Tuner C: Vuplus DVB-S NIM(45208 FBC) (DVB-S2)
FBC automatic
inactive

Tuner D: Vuplus DVB-S NIM(45208 FBC) (DVB-S2)
FBC automatic
inactive



Tuner E: Vuplus DVB-S NIM(45208 FBC) (DVB-S2)
FBC automatic
inactive

Tuner F: Vuplus DVB-S NIM(45208 FBC) (DVB-S2)
FBC automatic
inactive

Tuner G: Vuplus DVB-S NIM(45208 FBC) (DVB-S2)
FBC automatic
inactive

Tuner H: Vuplus DVB-S NIM(45208 FBC) (DVB-S2)
FBC automatic
inactive

Setup Tuner I: Vuplus DVB-S NIM(45208 FBC) (DVB-S2)
Configuration mode - simple
Mode - DiSEqC A/B/C/D
Port A - 28.2 Astra 2E/2F/2G
Port B - 23.5 Astra 3B
Port C - 19.2E Ku-band Astra 1KR/1L/1M/1N
Port D - 13.0E Hotbird 13B/13C/13E
Set voltage and 22KHz - no
Send DiSEqC only on satellite change - no

Setup Tuner J: Vuplus DVB-S NIM(45208 FBC) (DVB-S2)
Configuration mode - simple
Mode - DiSEqC A/B/C/D
Port A - 28.2 Astra 2E/2F/2G
Port B - 23.5 Astra 3B
Port C - 19.2E Ku-band Astra 1KR/1L/1M/1N
Port D - 13.0E Hotbird 13B/13C/13E
Set voltage and 22KHz - no
Send DiSEqC only on satellite change - no

Tuner K: Vuplus DVB-S NIM(45208 FBC) (DVB-S2)
FBC automatic
inactive

Tuner L: Vuplus DVB-S NIM(45208 FBC) (DVB-S2)
FBC automatic
inactive

Tuner M: Vuplus DVB-S NIM(45208 FBC) (DVB-S2)
FBC automatic
inactive

Tuner N: Vuplus DVB-S NIM(45208 FBC) (DVB-S2)
FBC automatic
inactive

Tuner O: Vuplus DVB-S NIM(45208 FBC) (DVB-S2)
FBC automatic
inactive

Tuner P: Vuplus DVB-S NIM(45208 FBC) (DVB-S2)
FBC automatic
inactive

**************************************************************

When I run the SATFINDER - all 4 physical connection - Tuner A and B - Tuner I and J - they all show a very good signal.

Any help for setting this up would be appreciated.
Looking forward to getting this to work.

Many thanks already.