V-Box on BlackHole

anacondama

Vu+ Newbie
Hey everyone,
i've just installed Black Hole and i want to ask if it's possible to add v-box to change satellites in automatic way.
Thank you
 
i have 11 sat from 30W to 28.2 E
So you have to choose the advanced mode and install them one by one in the fist one you choose lnb1, and choose 1.2 in the diseqc*mod do the same for all your sats one by one. The only different that your going to have is in use*usals*for*this*sat you write 001 for the first one ... so you are going to have 11 sats beginnig with 001 and finiching with 011.
I wish that is going to work for you :)
 
I have Strong positioner + actuator and i use these settings in my receiver to move the antenna between 30W - 45E.
In the last line = Stored Position 002 , you must put the position of your sattelites from the V-Box.

L.E. : the problem was solved, you can delete my post.

73353012.png


49779098.png
 
Thank you for your response
But i have an other probem that Hd channels singal become low (30%) specially Sky italiya HD after i connect the V-Box to the Solo ... So no more Sky Hd :glare:
 
Thank you for your response
But i have an other probem that Hd channels singal become low (30%) specially Sky italiya HD after i connect the V-Box to the Solo ... So no more Sky Hd :glare:

I think that your v-box have a problem when i use my vbox the signal is the same
 
Back
Top