This board is now closed. The Blackhole image ended in 2020. The board will remain available in Read Only Mode, so all the posts from the last 15+ years are not lost. We thank you for being part of the community for the last 15+ years. You can join the OpenBh board if you have not already done so at www.openbh.net.

vu Duo settings after recording

J

jrbmw

Vu+ User
After recording using bh 1.6.2 final image on the Vu+ duo theres no option for the receiver to go to standby , or is it the image is corrupt. I dont want to reload the image as I have to initialise the hdd and thus lose all the films I have on it.I am sure this option was there previously
 
Why would you need to reinitialise the HDD? That's a one-off operation when you set up for the first time, so re-flashing the image doesn't affect the recordings on the HDD.
 
For On Off button Standby you can configure in

Main menu >>Setup>>System>>Customize>>Action on long and short powerbutton press
but Menu Customize must be in Setup Mode Expert and not in Setup Mode Simple.

==============================

Standby must be also in the Main Menu>> Black Hole Shutdown
at the end of the Menu List Black Hole Shutdown panel.
 
The standby option for on off button is fine .Its after a recording is made where is the option to go to standby . Sonc the hdd has to be reinitialised if reflashed or although the vu sees the drive and mounts it ,it dont record !
 
I'm not sure I understand your question.

If you mean the option in the Timer Entry panel

It is located at the end of the list
After event>> You can choose auto, do nothing or go to standby function...
 
You must log in or register to reply here.
Back
Top