This board is now closed. The Blackhole image ended in 2020. The board will remain available in Read Only Mode, so all the posts from the last 15+ years are not lost. We thank you for being part of the community for the last 15+ years. You can join the OpenBh board if you have not already done so at www.openbh.net.

Vu+Solo balck screen for 1 sec

O

opensol

Vu+ Newbie
Hello!
I have Vu+Solo with latest BH image installed. receiver connected via HDMI to Pioneer A/V receiver.
Sometimes (once per 3 - 5 minutes) my screen gone black for 1 sec, without loosing sound. It's happens when menu are on screen or during SAT channel watching.
The same HDMI cable and A/V input was used before for connecting another sat receiver - without the same problem ..
 
opensol said:
Hello!
I have Vu+Solo with latest BH image installed. receiver connected via HDMI to Pioneer A/V receiver.
Sometimes (once per 3 - 5 minutes) my screen gone black for 1 sec, without loosing sound. It's happens when menu are on screen or during SAT channel watching.
The same HDMI cable and A/V input was used before for connecting another sat receiver - without the same problem ..
Click to expand...

Try to change HDMI cable, check settings on your AV System
 
the same with another two cables - one taken form XBox, another one from Vu+ Solo set
there is no any settings for HDMI on my AV system. The same input are working ok with other devices
 
opensol said:
Hello!
I have Vu+Solo with latest BH image installed. receiver connected via HDMI to Pioneer A/V receiver.
Sometimes (once per 3 - 5 minutes) my screen gone black for 1 sec, without loosing sound. It's happens when menu are on screen or during SAT channel watching.
The same HDMI cable and A/V input was used before for connecting another sat receiver - without the same problem ..
Click to expand...

Try with FTA (non crypted) channel.
 
This happens sometimes, if my router is restarted. Try to test without WLAN, if you are connected to WLAN.
 
Hmmm, looks like it's compaibility problem between A/V receiver and Vu+Solo.... is it possible to change HDMI version or other low-end hdmi settings ?
 
opensol said:
Hmmm, looks like it's compaibility problem between A/V receiver and Vu+Solo.... is it possible to change HDMI version or other low-end hdmi settings ?
Click to expand...
No, HDMI version is defined by HW. Solution could be Spdif audio connection to receiver and HDMI switch for TV-Solo-Receiver Video signal.
I can't give you more tips. I don't know your AV stuff configuration :)
 
paolino said:
I can't give you more tips. I don't know your AV stuff configuration :)
Click to expand...

It's pretty simple - Pioneer VSX-520-K Receiver are used for swithing between 6 HDMI Videosources. 5.1 Sound system connected to A/V Receiver. One cable HDMI goes to TV...
 
Looks like there is no solution for this problem... but there is a workaround - using YPbPr + TossLink to HDMI converter... it cost me 20 EUR + 1 component cable + 1 more power socket used :)
 
You must log in or register to reply here.
Back
Top