This board is now closed. The Blackhole image ended in 2020. The board will remain available in Read Only Mode, so all the posts from the last 15+ years are not lost. We thank you for being part of the community for the last 15+ years. You can join the OpenBh board if you have not already done so at www.openbh.net.

Vu Solo Update Problem

W

Williamvusolo

Vu+ Newbie
i don't have much experience with Vu+ solo receiver. Recently I bought a new receiver and tried to upgrade the firmware. First I inserted usb with the boot file and after I inserted a formatted usb with the three files required. First the led became constant orange/red then after two/three minutes became red and after few sects orange blinking, after another few second the green lede started to blink. The problem: When i unplugged the set and switch on for the first time after the upgrade of the 1.7.9 the led is constant green with black picture on the tv.

Can any one help please:?

Thank you..
 
Williamvusolo said:
i don't have much experience with Vu+ solo receiver. Recently I bought a new receiver and tried to upgrade the firmware. First I inserted usb with the boot file and after I inserted a formatted usb with the three files required. First the led became constant orange/red then after two/three minutes became red and after few sects orange blinking, after another few second the green lede started to blink. The problem: When i unplugged the set and switch on for the first time after the upgrade of the 1.7.9 the led is constant green with black picture on the tv.

Can any one help please:?

Thank you..
Click to expand...

1. upgrade Solo CFE
2. reflash the Solo with your favourite image
 
You must log in or register to reply here.
Back
Top