Request VU+ Uno: Picture problem when starting

irsoy80

irsoy80

Vu+ User
Image: BH v1.7.4
Box: VU + Uno

Each time, when I shuts down my receiver and I open it tomorrow, I should wait 5 minutes until the picture is stabilized, like as if there is no signal.

Could you help me please.
 
irsoy80 said:
Image: BH v1.7.4
Box: VU + Uno

Each time, when I shuts down my receiver and I open it tomorrow, I should wait 5 minutes until the picture is stabilized, like as if there is no signal.

Could you help me please.
Click to expand...

Very strange...
Check HDMI cable, coax cable and dish align.....
 
- HDMI Cable: is OK and work fine with other receiver.
- Coax cable: is OK and it is new.
- Dish align: OK.
 
irsoy80 said:
Image: BH v1.7.4
Box: VU + Uno

Each time, when I shuts down my receiver and I open it tomorrow, I should wait 5 minutes until the picture is stabilized, like as if there is no signal.

Could you help me please.
Click to expand...

@Reception Settings try to:-

Set Voltage and 22KHz.......YES
&
Send DiSEqC only on satalite change.......YES
 
Hello and good morning all,

Yesterday I installed the official image in my VU + successfully and I switched off the receiver.
This morning I turned it on ..... Oops, the problem persists.!
 
Image: BH v1.7.5
Box: VU + Uno

- I have installed the new image BH v1.7.5
- HDMI Cable: is OK and work fine with other receiver.
- Coax cable: is OK and it is new.
- Dish align: OK.
- Hdmi Cec: Is disabled

==> After 12 hours, I start the server, But The problem persists.!!!!!!!!!!

Shiro said:
try to disable Hdmi Cec
Click to expand...
 
irsoy80 said:
Thank you for your HELP...
Click to expand...

Im sorry, your problem is obviously not in direct relationship with the image, but with something else.
And it is not allowed on this forum.
We have to respect our rules for the benefit of all users and members of our team.

Rgd MX
 
You must log in or register to reply here.
Back
Top