This board is now closed. The Blackhole image ended in 2020. The board will remain available in Read Only Mode, so all the posts from the last 15+ years are not lost. We thank you for being part of the community for the last 15+ years. You can join the OpenBh board if you have not already done so at www.openbh.net.

Vu+ Zero Openpli Motor Setup using Usals

R

Roccu78

Vu+ Newbie
Hi pros,

Have changed image of my Vu+ Zero to OpenPli. The box was set with a Motor all working fine but i lost all settings with the image change and don't know what settings it had before.

Can i find a guide how to setup motor using Usals ?

Do i need to move the motor manually "reset" or if i put the lat long positions all will be ok ?
 
Roccu78 said:
Hi pros,

Have changed image of my Vu+ Zero to OpenPli. The box was set with a Motor all working fine but i lost all settings with the image change and don't know what settings it had before.

Can i find a guide how to setup motor using Usals ?

Do i need to move the motor manually "reset" or if i put the lat long positions all will be ok ?
Click to expand...

Here ... only support for Blackhole and Open Blackhole images.

So, ask on OpenPli forum.

best regards
nunigaia
 
You must log in or register to reply here.
Back
Top