This board is now closed. The Blackhole image ended in 2020. The board will remain available in Read Only Mode, so all the posts from the last 15+ years are not lost. We thank you for being part of the community for the last 15+ years. You can join the OpenBh board if you have not already done so at www.openbh.net.

zero strength/signal on my satellites

V

vu_rocks

Vu+ Newbie
vu+ solo user. I use DiSEq C A/B (hotbird 13e and eutelsat 3.1e) on the same Tuner. Since yesterday i got 0 signal on both satellites, on all channels. I suspect it's the LNB or my wiring. Is there anyway i can check whether it's actually not my settings before i call my technician to check my satellites on the roof? thanks
 
vu_rocks said:
vu+ solo user. I use DiSEq C A/B (hotbird 13e and eutelsat 3.1e) on the same Tuner. Since yesterday i got 0 signal on both satellites, on all channels. I suspect it's the LNB or my wiring. Is there anyway i can check whether it's actually not my settings before i call my technician to check my satellites on the roof? thanks
Click to expand...

Hi

VU_ROCKS


1) Check the connections.

2) Remove your DISECQ comutator and test the two cables ... one by one, attaching them to your receiver, you will have to make perhaps a union with a male/male f conector.

3) Check first of all, the settings you have made on your STB.

4) Check the plastics of your LNB ( Feed ) .... Dust or if they are broken.

best regards
nunigaia
 
look for a bad contact in your diseq: i had the same, and altough the connector looked in place, a simple twist on the cable made the signal come back.
You can also check on the menu of the box to check with you has "strenght" in your satellite....
 
You must log in or register to reply here.
Back
Top