HELLO HAMEDSTAR
I've just bought a new VU+ solo SE v2. a clon not original I bought it from aliexpress
and the enigma is openpli 4.0
can I install the black hole BH 3.0.2 F like you did
pleas tell me how to install it .
thanks
hi how are halim, first of all congratulation for your box
1- download the image
2- flash usb format in fat 32
3-unzip the image and copy folder name vuplus direct to usb
4- make sure that folder image name is vuplus
Flashing the Receiver.
– Fully power the receiver down by the toggle switch at the rear of the receiver.
– Make sure no USB devices are plugged into the receiver at this point.
– Insert the USB stick containing the image files into the USB port on the receiver.
– Power the receiver on.
– The Blue L.E.D will quickly flash two or three times then start to fade in and out slowly.
– Once completed the Blue L.E.D will flash rapidly.
– If in doubt leave the receiver for a full 10 minutes before powering down and removing the
USB stick.
any question just send me make
but i did not that you receiver support this image or not
please tell me the how much is your receiver.