sorry
need some help
but how to install it?
i've written it to flash drive
connected to vu+
and when i turn it on it doesn't begin installing from flash drive
what am i doing wrong?
thanks
thanksWhy you use old image ?
The procedure is always the same.
Be sure you have
1.Formatted stick Fat32
2. You have unzip the ZIP image file
3. you have copy all the folders and files in folders on a USB stick
4. That only USB stick is connected to the box.
If it fails to flash try with other USB sticks.
what do you mean? I want BH with MX SkyLine SkinWhy you use old image ?
I have more of them but only one works with my solo2If it fails to flash try with other USB sticks.
don't seem but i am ))You do not seem to be a beginner.
Maybe this one you have does not work for some reason
Otherwise I also did not know the reason...
don't seem but i am ))
i do it once a yearand don't remember what i did last time))
thanksDon´t forget to remove all your usb devices attached to your SoloSe, before puting the usb stick that contains the new firmware for flashing it. ( This includes tuners, Usb HDD, etc ... i.e. all usb devices ).
best regards
nunigaia
thanks
i do so, thats the point
can't get why it doesn't work...
ps i have solo2
thanks
i do so, thats the point
can't get why it doesn't work...
ps i have solo2
i'm sorryOk, sorry my mistake, but you have posted too, in SoloSe section, and that is the case because i´ve referred SoloSe and not Solo2.
NOTE: I´ve moved this thread regarding Solo2, because was posted in SoloSe section.
best regards
nunigaia
I would say it without PictsProbably to check if it's genuine, or a clone.
Probably to check if it's genuine, or a clone.
I would say it without Picts
I know what I buy, usually![]()
I would say it without Picts
I know what I buy, usually![]()