BH Problem on my Duo2

[Etel]

Thank you for your reply, I have previously tried that only to obtain the same problem, any other advice would be welcome

 

[Eragon]

Then finally try removing also all the internal tuners.

 

[Etel]

Do I actually need to remove the tuners or just the connecting cables?

 

[Eragon]

Remove the tuner modules.

 

[Etel]

Remove the tuner modules.

Thank you, I will give it a go - regards

 

[Etel]

Removed both the tuners, box worked fine and loaded blackhole 2.1.5 ok, the moment I put the tuners back in the box would not boot up, removed the tuners out again and the box booted up OK. Any suggestions would be greatly appreciated.

 

[Eragon]

Check which of the modules is the responsible.

 

[Etel]

I have two tuners but I had to remove them both in order for the box to reboot again, I did read somewhere that if the time on the box was not correct (obtained from the satellite) this could cause a problem, any further advice greatly appreciated.

 

[Eragon]

Unfortunately I've no further suggestions to give...

But if the time was the culprit, the box should still boot without any cable connected...

 

[Etel]

Thank you for all your help, clearly it is a software problem.

Any further advise on this site is greatly appreciated.