Change over from OpenViX to BlackHole

D

dwatson

Vu+ Newbie
Hi all,
I have a Vu+ Duo2 receiver which came pre-installed with OpenVix. How do I convert it to Blackhole?
Many thanks.
Khan
 
dwatson said:
Hi all,
I have a Vu+ Duo2 receiver which came pre-installed with OpenVix. How do I convert it to Blackhole?
Many thanks.
Khan
Click to expand...

Install Black Hole
The same procedure as for all other images.
Search on the forum or on the www net,how to install images.
 
Thanks all. Tried doing that via USB stick via front USP slot of the receiver but the ViX is too stubborn and does not get overwritten. Tried 2 USB sticks formatted to FAT32. Any ideas/suggestions please.
 
Did you format the sticks to FAT 32?
Switch off the receiver, at the rear, insert your USB stick, into the front USB slot, behind the flap, turn on the receiver, at the rear, and hold in the power button, near the USB slot, behind the front panel.
If it still will not load check that you have the latest updated boot loader:
http://www.vuplus-community.net/board/threads/duo2-cfe-bootloader-update.13413/
You should see this on the front screen, after switching the power back on.
 
You can also run other images, from your USB, using the multiboot option, including VIX.
When I have time I hope to have a play with Open Black Hole and the multiboot option.
 
You must log in or register to reply here.
Back
Top