Udpxy is also essential part of this and it can be installed on PC, router (if you have Tomato capable router, please consider installing Toastman Tomato mod. This mod already has udpxy installed!) or satellite receiver. Udpxy converts multicast to unicast and and it enables you to use IPTV on all your home devices (mobile phones, PCs, nootebooks, tablets, etc.). I assume you already have udpxy installed, so i wont go further in details here.
Lets move on. You will now need these:
1. Notepad ++ editor
2. FTP program (WinSCP, FileZilla, FTP is also included in Dream Control Center program – DCC)
3. DCC-E2
4. Channel list of IPTV streams that are converted in Enigma2-friendly streams
Now run the DCC program and conect with receiver. Once you are successfully connected to your receiver, search for word “Telnet” on the left side of DCC. Then type “init 4″ into console. Now you can use FTP to transfer IPTV channel list to the folder /var/etc/enigma2/. When finished, enter “init 3″. The receiver will reset and the channel list should be seen.
How does Enigma2-friendly stream looks like? Here it is:
#SERVICE 1:0:1:0:0:0:0:0:0:0:http%3a//127.0.0.1%3a1234/udp/239.1.1.115%3a5000
#DESCRIPTION BBC
Bolded numbers are IP and PORT used by udpxy program. If you have udpxy installed on the satellite receiver than you should leave 127.0.0.1, but if you have udpxy installed on PC or router, you must change IP (IP should match IP of the router or PC). 1234 is default udpxy port. If you are using different port, change this to something different of course. “/udp/239.1.1.115%3a5000″ is IP and port number of a IPTV channel. Every channel has different IP. Port is usually the same for all channels, but not always. It depends on your IPTV provider. EPG doesnt work on these channels because service reference is the same for all channels: “1:0:1:0:0:0:0:0:0:0:” Service reference can be changed though but this requires too much work!
If you only want to stream between receivers, please use this handy plugin: remotestreamconvert. Its very lightweight plugin and it comes handy when you have following situation:
1. Primary receiver with 8 satellites
2. Secondary receiver with only 4 satellites