USB DVB-T do not detect Mediaset channels

[starchaser]

Ciao

I have a Vu+ Solo2 with BH 2.1.3 installed.

With the Sky DVB-T USB Tuner I see all the channels but most of the Mediaset channels (while it works perfectly when I plug it on the TV). The signal rate go to 0% (sometime blinks to hgher values but then it goes back to 0% immediately after).

To try to fix the problem I first bought a LTE Filter (as suggest is some posts here) but it did not work. I had same issue as above.

Then I bought a different USB Tuner, a DVB-T2 (a white labeled DVB-T2 USB TV Stick HD-901T2), but apparently this second Tuner is not supported (it is recognize by the Vu+ as a DVB-T2 tuner but it doesn't work, as no channels are shown).

Please, can you help ?
Thanks

 

[angelofsky1980]

Ciao

I have a Vu+ Solo2 with BH 2.1.3 installed.

With the Sky DVB-T USB Tuner I see all the channels but most of the Mediaset channels (while it works perfectly when I plug it on the TV). The signal rate go to 0% (sometime blinks to hgher values but then it goes back to 0% immediately after).

To try to fix the problem I first bought a LTE Filter (as suggest is some posts here) but it did not work. I had same issue as above.

Then I bought a different USB Tuner, a DVB-T2 (a white labeled DVB-T2 USB TV Stick HD-901T2), but apparently this second Tuner is not supported (it is recognize by the Vu+ as a DVB-T2 tuner but it doesn't work, as no channels are shown).

Please, can you help ?
Thanks

first of all, the comparison between a cheap USB DVB dongle and a TV set is WRONG because TV has a lot of electronic to manage the signal .... the cheap USB dongle hasn't.
Try to enable 5V in your box to give more power to your USB DVB dongle ... also the problem you mention is caused by a antenna orientation problem or no sufficient power to your USB device (it can be solved with a powered hub USB9.
About your second device, it's not fully supported due to linux driver developing from open source community and should be supported ASAP the driver will be avaiable to the Linux community.

 

[starchaser]

Thank you for the very prompt reply !!

I've enable 5V, same problem.

I'll buy a powered USB hub. If that won't work I'll call an antenna installer

Looking forward for a new BH release with HD-901T2 support.