vu+solo2 flash new image

[afalk]

my vu+ solo 2 will not read usb stick, i have tried 5 different usb sticks but the update prosess does not start, the box just boots up after some time

 

[Mick12334]

Having read some of your older posts, you used to have a VU+ Solo 2, and a VU+ Duo2, so i assume that you've flashed both receivers, so know the basics.
Always format your USB stick, to FAT 32, using your PC.
Unzip the image, and load the vuplus folder, onto your freshly formatted USB stick.
Remove any other attached USB devices, before trying to load a new image.
Power Off Solo2
Insert USB Pen Drive in the front USB socket.
Power on Solo2

If this fails try inserting the USB stick into a different USB socket.

 

[afalk]

have tried that, but it just start booting after aproximate 30 seconds

 

[Mick12334]

Try a different image:
https://www.vuplus-community.net/board/threads/openbh-4-4-vu-solo2.41668/

Or the original vuplus image:

http://code.vuplus.com/index.php?action=image&image=30&model=vusolo2

 

[afalk]

tryed that too, but the same problem, flashing now via rs232

 

[mccann007]

tryed that too, but the same problem, flashing now via rs232

are you sure you can flash it via rs232 ??

 

[sagher]

are you sure you can flash it via rs232 ??

Amazing if you do that..
do you have flash backup "nfi" file??
if you have please upload here.
my box vuplus_solo2 stuck on "starting.."
try almost all ways to recover but fails..
i hope with vucc emulator and rs232 i can do it.
but for this i need nand flash backup "nfi" file