This board is now closed. The Blackhole image ended in 2020. The board will remain available in Read Only Mode, so all the posts from the last 15+ years are not lost. We thank you for being part of the community for the last 15+ years. You can join the OpenBh board if you have not already done so at www.openbh.net.

xxxx

Status
Not open for further replies.
V

vamas

Vu+ Newbie
I think that I have correctly installed ***** in my vu solo bh 1.7.8,
My blue panel is showing the following:
***** 2.30 - OK
2 cams installed < set default Cam>
Active ***** 2.30
channel details...
ecm info not active

Can any one point out to me if this is correct or should i be doing something to get all to work?

I have tried .lines to no avail

thanks for an answer
 
Status
Not open for further replies.
Back
Top