I purchased an old (2012) Vu+ Duo that had been running the 2.1.5 BlackHole firmware. The guy I bought it from showed me it working, set up with channels from South Asia.
I looked up and update and saw that one was available, and did a factory reset of the box before doing an update. I installed a 1TB SATA had drive, and that is recognised and sets up fine.
However, ever since the factory reset, BlackHole only says "Loaing GUI..." and I get no further.
It will USB flash to newer versions, and I even tried OpenPLI and another firmware, but all seem to stall on the same issue in that the user GUI just won't load.
I can configure the network, and go through the basic set up wizard and satellite tuning, but I just never get a GUI or a tuned channel to display.
What am I doing wrong?
Thanks all, any help gratefully appreciated.
A
I looked up and update and saw that one was available, and did a factory reset of the box before doing an update. I installed a 1TB SATA had drive, and that is recognised and sets up fine.
However, ever since the factory reset, BlackHole only says "Loaing GUI..." and I get no further.
It will USB flash to newer versions, and I even tried OpenPLI and another firmware, but all seem to stall on the same issue in that the user GUI just won't load.
I can configure the network, and go through the basic set up wizard and satellite tuning, but I just never get a GUI or a tuned channel to display.
What am I doing wrong?
Thanks all, any help gratefully appreciated.
A